Switching

I have a Catalyst 3500XL ( WS-C3508G-XL) with 8 Giga interfaces and a Catalyst 3550 linked with a fiber, working ok.Now i have replaced the C3550 for a C2960. But I cant make the link up connecting the C2960 with the 3500XL.I had to change the fiber ...

Hi all,I'm trying to configure PBR on a Catalyst 4500 with Supervisor 6E running version 12.2(46)SG Enterprise Services.I'm not able to configure PBR on the interfaces using the command ip policy-map.Did this feature disappear on this Supervisor???I'...

What is the sequence in which a route processor will decide a the best route to destination?

Hi,We have a pretty standard network, with distinct data, core, distribution and access layers. The data centra, core and distribution layers are all layer 3, with Layer 2 at the access layer.The WOL server (Alteris deployment server) is on a vlan on...

HelloI am trying to establish an etherchannel based on LACP between 3750 and 6500. The problem is that the channel do not want to establish. On 3750 side it shows6 Po6(SD) LACP Gi1/0/1(H) Gi1/0/2()and on 6500 side it shows Po6(SD)...

Hi,I have a core switch Cisco 3750G (1 No) and Cisco 2960G (7 Nos).I have successfully created " Etherchannel between Cisco 2960 G (6 Nos) to Core Cisco 3750,when I am trying to configure the ether channel between the 7th Cisco 2960 G to the core cis...

If were to use OSPF as internal BGP, would we need to create the ajacencies between the int on the router or can we just passive-interface them?Thanks..

2008 Aug 20 05:58:23 EDT +10:00 %SYS-3-FAB_SYNCERR:SYNC ERROR detected on fabric channel 5 from module 82008 Aug 20 05:58:25 EDT +10:00 %ETHC-5-PORTFROMSTP:Port 7/1 left bridge port 7/1,8/12008 Aug 20 05:58:25 EDT +10:00 %ETHC-5-PORTFROMSTP:Port 7/2 ...

are the 2960 switches layer-3 switches?

When my IP phone boots up on this port the MAC address of the phone shows up in vlan 1 the native vlan which also is currently used for DHCP until DHCP devices are transitioned to vlan 6. The phone grabs an IP address in vlan 1. After 2 minutes or ...

I'm currently running this on my 6509's:s72033-ipservicesk9-mz.122-18.SXF.binI'm going to run layer 3 all the way to the access switches, can anyone suggest a stable version I might want to upgrade to? Or is this one adequate? Eventually, I'll be r...