Switching

Hello all i have a 4500 with a static arp entry for a virtual server. all has been working fine for 6 months. config below.arp 94.240.129.133 03bf.5ef0.8185 ARPA aliasi have now enabled multicast routing on the 4500 and added a pim statement to the v...

Can some explain the loose, strict, record options in extended ping. also examples.cheers.

I am adding a second 2MFT-VWIC in 2821. do I need to add the card type t1 0 1 command in the router for router to dectect it?Thx

I have been running into some problems finding information help!

Good morning, i've got a problem they i'd liek to share with you.We have 2 networks , each on a router .On router 1: 192.168.1.0/24On Router 2: 172.16.1.0/24On each router there'ss a switch connected and on each switch there are different servers con...

When a link has failed, and uplink fast has done its thing, and the failed link comes back up, the change over to the restored link is delayed for 35 seconds to allow the far end of the recovered link to do its standard STP process. My question is on...

Is there any way to find out user system connected to which jack panel.

How to find which port connected to UPlink

All,I need to be able to NAT to specific addresses on a destination basis. As you can see from my config below I have created a pool (POOL_1) and created a NAT statement that says... NAT traffic that matches the ACL 100 to an address in POOL_1. How...

I have received the following message forn a 3750 Switch:10366: Jul 31 09:21:28.444: %SW_MATM-4-MACFLAP_NOTIF: Host 00a0.f856.f438 in vlan 198 is flapping between port Fa2/0/21 and port Fa2/0/30Please, any help on what it means and how it can be solv...

Hi All,We currently have several 3750 switches spread between floors with dual fiber uplinks between each floor and the server room. I have been asked this question. Is it possible to get a stackwise cable that runs the entire length of floors to c...

I need your help. I have two ISP's going from my network to my other location. I want simply to route my SMTP traffic through ISP1 and all other traffic through ISP2. I don't want to use PBR on 6509 switch since that will include all ports on that vl...