Switching

I have a PIX506E as the firewall between my LAN and my ISP. The power supply failed and while waiting for a replacement, I replaced the PIX with a Netgear router. This worked for what I needed (Internet access for browsing and email). When I went ...

Hi,We have a campus designed network that have a core level: 10720 routers on a ring topology, a distribution level: 3750 switches with ip routing, and an access level: 2950,2960,3550 POE and 3560 POE layer 2 switches. I want to know how many switch...

Dear siri wanted to know that how can i hear voice in my voice vlan. as i m using 2801 voice gateway with PRI (only PSTN connectivity) ,and 3560 switch for voice and data vlan. My voice gateway IP is 192.168.1.221 and is data Vlan on port 7 as menti...

Hello,I am trying to configure OSPF so that in case of network split OSPF does not advertise a connected route anymore.I am trying to make this work like this.In case IP address 172.20.240.5 does not ping, OSPF withdraws a route for 172.20.240.0/29Th...

we have a 2 sites connecting by a Private Line(T1), in one of this sites, we don't have Internet access.I want to redirect the internet access from the site where we do not have access, throught of T1, to the Site where already have Internet access.S...

Hi,do you think is possible to transport over a backbone (with VRF for multiple customer) a specific QoS for a specific customer?i'll explain:(customerA network1) -- customerA CPE -- PE -- (P backbone) -- PE -- customerA CPE -- (customerA network2)so...

Hi I wish to setup a site to site connection using a layer 2 network. Can you recommend the type of cisco swithc i need for this. I require the following setup:Layer 2 site to site VlansQOS Routing

What is the rule of thumb here? I must have at least 6 of these. My Dell BladeServers were config'ed as "server" as is my Core 6513 switch. I know that need at least 1 backup.Would love to make my Dell's "Client" but that might make Mgt uneasy, but c...

I have a 3560 switch and I am getting the following error. Base ethernet MAC Address: 00:1f:c9:96:60:80Xmodem file system is available.The password-recovery mechanism is enabled.Initializing Flash...flashfs[0]: 452 files, 6 directoriesflashfs[0]: 0 o...

Hello, Very basic question..which is throwing me off. We never use this in Production environment. But when we have an access-list like followingaccess-list 1 permit 0.0.0.0 255.255.255.255This means..we are allowing any host ( 0.0.0.0) and what ...

Will the conversion utility migrate the CatOS running-config (what vlan a port is on) to Native IOS? From the below link I understand the answer is 'no', it just upgrade it and I get no config.How to Convert a Catalyst 6500/6000 Supervisor Engine fr...

I am looking for a way to add an extra ethernet port on my 2610. What i have read is making me wonder if the only way to do this would be the NM-1E or NM-4E. Are there any other modules or WICs that would give me an fast/ethernet port?Thanks,Kyle