Switching

Hi everyone I have a few questions about the 1811 router Is it possible to configure the router to use WAN0 for Lan user internet access and WAN1 for wireless user internet? We will be using 2 different internet providers, one being DSL WAN1 and th...

Hi allI'd like to find out how many DRAM memory slots are there on a Cisco 2651XM router and whether they're occupied by a memory module or not. Is there a command available that can do this? I currently have 128MB RAM on this router and is looking a...

Hello,I have au CALLMANAGER with follwing version:1-cisco CallManager System version : 4.1(3)sr3a2-Cisco CallManager Administration version : 4.1(0.11)3-Cisco CallManager Installation ID:4.1(3)sr3aI want to upgrade to the last disponbile version.Ple...

Not sure if this should be in the LAN or WAN section, but here it goes....I have setup a Cisco 2801 that I had sitting around in the office to see if I could use it as a alternate gateway for some of my LAN clients to get access to the WWW.I am havin...

COMMAND TO SHUT DOWN ROUTER

During the course of studying, I came across some security features for switch ports. I am about to put a Cisco switch on my home network and would like to specify the time of day that a client PC can use the port. (e.g. the port is allow traffic f...

HiDoes cisco 877 support single Static Valid IP for NAT and PAT or Do I need an addition Valid IP for PAT ?I configure the NAT (Dynamic) for my Internal LAN to access the internet, it works fine but I can't get the PAT for port 25 to reach my interna...

Scenario 1: You have a conference room that is configured to support meetings of users on segregated networks each with a DHCP server. Manager fiddles with ethernet cable connected to a port in the conference table. Absent-mindedly connects the ot...

i have 2 switches 6509 and 6513i connect with two link one is Fiber and other one is Wireless how to make load balance using different media

I connected one layer 3 switch to Hub as shown in the attached fig.I want to know which port will be come designated port, non designated port ,root bridge and root port.

Everyone, First, here is the setup: 2 6500's with dual Sup 720's connected together with dual Gigabit etherchannel 802.1Q trunks. Redundancy mode is SSO/NSF and they run in native mode Each router runs HSRP for the VLANS shared between them. One is ...