Switching

Hi,I am having a 7206VXR router with NPE-300.To rectify bus error I just replaced the NPE-300 card. But now the router is not booting from flash. The router is hanging while booting and we can manually boot from rommon. What could be the issue ?Thank...

This message pops up on the console of a 7206 router running IOS 12.2(15)T14. I can't find a reference to it on CCO in either the 'output interpretor' or the error message locator.There are no debugs turned on, no special SNMP configs other than the...

Hi,I have a 6500 with two sup720's installed they are in an active and standby state.They are both running in a hybrid mode using CatOS cat6000-sup720k8.8-3-6.bin & c6msfc3-psv-mz.122-17d.SXB9.bin on the MSFC3My question is, is there anyway to view t...

Guys,I have a 6500 running with WS-6724-SFP fibre gigabit cardsNow, some interfaces show the input queue (when the port is disabled) as 2000 and when enable at 75 as belowGigabitEthernet1/19 is administratively down, line protocol is down (disabled)...

hi, when i entred by hyperterminal to verify the SW image, i have find C3750-IPBASE-M ! it's correct? because normaly i find IP Services Image. i want to confirm this if there is somebody who worked with with 3750-TS-E.thank u.

Hi all, is there a standard what most people use for there colour of cat 5 cables, ie , crossovers, routers, clients etc ?

is there any Commands Must be enabled on the 6509 Sup 720 regarding Win Vista Networking to work properly???

hii have configured VLANs on cisco catalyst 2924XL, the issue is that when i enable the trunk mode its status goes down...any idea y?

Hi all, can anyone tell me if you can have a port that is a tagged member of say vlan 10 and an untagged member of vlan 5 ? I have seen this on nortel switches on a normal access port ? i would of thought this would be classed as a trunk port ?

Is there some tcpdump'like reliable packet sniffing tool in IOS?I tried to use "debug ip packet", but it doesn't dump traffic, passed over NAT.

Hi all, can anyone enlighten me on how this works through firewalls, does it tunnel through port 80 or something ?

R1#sh ip bgp 170.190.140.0 255.255.255.0BGP routing table entry for 170.190.140.0/24, version 1324996Paths: (2 available, best #2, table Default-IP-Routing-Table)Multipath: eBGP Not advertised to any peer 64806 64872 64852 64851 64871 64811 65531 6...