Switching

Hello,while planning snmpv3 migration of our cisco components I found out that the "snmp-server user" commands are not shown in the running or startup configuration.Does somebody know what is the reason for that special behaviour?Because of this beha...

I know there is a simple answer for this but I need confirmation. The 3750 mentioned above states that it does PoE on all 48 ports. Is that all ports can do PoE at the same time without a power upgrade? I need to support 12 LWAPs and don't know if...

Hello!how to consider the STP Topology for Ur Network if U run glbp.network Setup in the Attached File10xs

I'm configuring VLAN's on a Cisco 3550 & 2960. The 3550 is a layer 2 & 3 switch. I've configured the "router on a stick" config before but this is the first time on a layer 2 & 3 switch. Then trunking to 2960 thru gi ports.How would I connect the VLA...

I would like some input on a project I am working on. I am a novice when it comes to network and router configuration so please bear with me.I have two companies that share the same backbone. I want each company to have their own router so when one...

Can I configure a Cat 6509 running CatOS as a tftp-server? If so, how?Thanks.

Hellocheck this Eigrp Config for the Attached Diagrams:DS1riuter eigrp 10no auto-summaryPassive-interface Defaultno Passive-interface int port-channel 0network 100.100.100.1 0.0.0.0network 10.10.10.0 0.0.0.255!ip route 0.0.0.0 0.0.0.0 100.100.100.5!D...

Hello!I have vlan 100 which it has UP/DOWN STATUS.what is reason is?also computer in this Vlan port 1/10 Flap.how can i Trobleshoot?10xs Again

My company bought a Catalyst 2960(flash:c2960-lanbase-mz.122-35.SE5) but the logs at show log command are displaing a very delayed time from the current clock time (show clock) in the switch. Is it a IOS release issue or there is a specific command t...

Dears i have 6509 switch and i want the switch to boot from IOS image in Disk1 instead of the image in bootflash can anyone give me steps to do this taskThanks,

We are having issues with SPAN destination ports dropping packets after upgrading ios from s222-entservicesk9_wan-mz.122-18.SXF6.bin to s222-entservicesk9_wan-mz.122-18.SXF11.bin Has anyone experienced SPAN issues with this ios?

Good Morning, How do I get the switchport mode trunk off of this? Really I would like 0/23, 0/24 to be the same as 0/22. interface FastEthernet0/22 switchport access vlan 2 no ip address spanning-tree portfast spanning-tree guard root!interface FastE...

Dear all,Can Someone please explain to me about QnQ in Cisco as to what it is how it is done , in which series devices it can be done.Thanks in Advance

Dear all,hope you can help me with my issue.I need to know which catalyst i need for encryption. Is there a possibility with catalyst 2960, 3560 or 3750? thanks&brgds Rainer