Switching

Hi,I am wondering if it is possible to use VRF selection based on source IP address on a 3750-24TS-E. The IOS version is c3750-ipservicesk9-mz.122-25.SEE4.bin. The switch allows me to put the commands in but I get the following:SW3(config)#vrf select...

Is there a way to track an IP instead of an interface when using HSRP Tracking?

Hi,in my Campus Lan, i've one core switch (4506) and several acess swicth (2950)On an access switch i create a monitor sesion to get trafic for a particular port. Works fine.On another switch (not in the same stack), i create another monitor session ...

Does anybody have an idea what is the MTTR for access layer switches and core switches?Thnaks

HelloI have a switch WS-C3560G-24TS (L2-L3 image)I have a telecom provider equipment connected to the int g0/1 of my switch and carries to my switch different vlans from remote sites (L2L).The DG IP @ is definedin my switch.I just want to know what i...

Hi,I have installed a 2851 with 4 x ADSL-HWIC's. Using CEF it is balancing the load across the links. All up it is working well, however there is only one issue at this stage.On a few web sites you can access things fine except then when you click on...

Hi,I'm trying to set up remote access to a Cat 3548XL using reverse telnet from a Xyplex 1604 Maxserver. I have configured the Xyplex and can access 2600 routers and also Cat 3550 switches without any problem. If I take the console from the 3550 and ...

Hello every one, We are looking to upgrade our network to achive the followings : 1. To have latest technologies in place. 2. To utilized latest features for data, voice & Video. 3. To have fully redundant setup etc. So, I need your valiable recommen...

Hi there , I have an issue , on creating a birectional acces-list .For example :1.1.1.1 255.255.255.0 2.2.2.2 255.255.255.0 251.1.1.1 255.255.255.0 25 2.2.2.2 255.255.255.0Is access-list correct , can it been done in this way rather then , 1....

HiI've got a 3560 switch which I'd like to get to the rommon prompt. My question is how do I do that from the enable prompt. Currently its running through console and I'm accessing it via minicom on linux. Additionally I don't have physical access to...

Hi all, can anyone tell me the differences in the above, and what is the tos value, is that used for precedence where as diffserv uses the dscp value ? whats the difference ?

Hi all,I am having doubt about cpu usage below pasted can anybody explain. 1111111111111111111111111111111111111111111111111111111111 22777777777799999999998888888888777773333333333222221111121009080706050403020*********************************...

Hi all, I know i have mentioned this in the other forum, but i need a bit more clarity.If I say have a pc plugged into vlan 2, pvid of 2, i gather this means that if ant frame comes in untagged it gets put into vlan 2 right ? ok, well my confusion is...

Dear sir,Iam having 2924 switch in that frontpanal system light is glowing orange colour and 4 ports r glowing orange colour plz give reply why it was .Regardssrini9246571397