Switching

Hello,I have noticed a large number of output drops on one router interface on Cat6509(Sup720) on module WS-X6148-GE-TX (HW 5.0). This interface connects to externel router that leads to customer network. I am trying to figure out what are those lost...

I have a 7604 with a SIP-400 and a SPA-2GE. On one of the GE ports I have this config:int g2/0/1.50 encap dot1q 50 ip address 192.168.10.1 255.255.255.128router eigrp 1 network 192.168.10.0It is connected to a L2 3750 port with this config:int g0/1 ...

I've got a catalyst 2950 which I've just done the initial configuration on. I've set the IP address of the switch, and with a PC plugged directly in, I can reach it via ping, telnet, and http. However, when I plug the same port into another switch ...

Hi,Reposted this since I've not got any response over at career certifications.I have been thinking about working in this capacity and people who I have spoken with seem to think Cisco are a good employer. Cisco UK also have some vacancies at the mo...

Hi, this is my first time posting out here and i'm hoping i can find a bit of help. We've recently purchased 18 new 3750s to replace our 3548s and i've been tasked to swap them out if possible. I have some knowledge of switching and the Cisco CLI, ...

Hello all,I have 2 router connected via 2 LL links on WIC-2T modueles. When I've the 2 LL connected at the same time it cause one of the routers to hang. Anyone ever came across a simular issue?Regards,

Hi everybody,I've got a 6500 series router here with a 48 port module and was wondering if there was anyway that i can test that all the ports were functioning without having to physically plug them all in. Any help would be useful - it's running off...

When you have multiple ip helper-addresses configured on an interface, does the router/L3 switch forward the UDP packets in the same order as they are configured or does it forward them to all of the helper addresses configured, regardless of order? ...

Can you route between the two fixed ehternet ports on the 1841? i want to make one of them a WAN port

i had been using 2960 catalyst switch for connecting to server farm of late weswitched over to 6509 layer3 switch with sup32 engine how do i configure the device as layer2 because when i connect any host and access the net it gives request timed out

These are Virtual Connect - Enet switches installed in HP's C-Class Blade Enclosures and have their uplinks aggregated and connected to CAT6K switces and downlinks connected to NIC cards in Blade Servers in the enclosures. The uplinks can be LACP gro...

We have recently acquired a new 6509-E configured with two 6000W power supplies (currently one is disconnected). The power details are shown below:6509-E#sh powersystem power redundancy mode = redundantsystem power redundancy operationally = non-redu...

hi my comp is having 4507 switch it has 2 supervisor Sup V-10GE 10GE (X2), 1000BaseX (SFP). one of the sup which is in slot 1 is getting power off after working arouund 30 minutes no status power led nothing. checked the value of the Environment Vari...