Switching

Is it possible to limit the bandwidth in different VLAn's using QOS..i have 5MBPS internet connection ,with 254 public IP I did subnetting for this pool made separate vlan for each public subnet i have to share this connection in different VLAn's, ie...

Hi to all,I got a new C3750 installed on my network, which runs MSTP implementation against Allied-Telesyn switches using also MSTP.I have no problems in the past with MSTP using other brands, but now I do have a issue when I plug the C3750.When I co...

Anyone got an idea why this is not working ?ip local pool Pool16 80.248.16.16 ip nat inside source route-map RMNoNAT pool Pool16route-map RMNoNAT, permit, sequence 10 Match clauses: ip address (access-lists): NoNAT Set clauses: Policy routing ...

HiIt's possible to creat a script and the switch boot for it?The swich 2950, the ports 18-48 it's down the command "no shutdown" don't up the port.By console, power off/on in the equipment, I see a message like "Compiled by antoniocpd_port_enable".An...

I have 2 7206VXRs with Tunnel interfaces configured. One side of the tunnel is mapped to a Serial interface and the other side is mapped to an Multi-link T1 bundle. The MU tunnel interface is showing up/up but the serial interface is showing up/dow...

I am trying to block a certain host on port 80, but can't seem to get the ACL syntax correct and also can't bound it to an interface. Below is the commands that I have entered. deny tcp host xx.xxx.xx.xxx any eq 80permit ip any anyI have also added t...

All, What is the negative, if there is any, to having 3 VTP servers in the same domain?

Say I want to set up 2 networks.I dont want to route between them and I want them to be on the same switch.So I want each computer to be part of 2 network.What is the best way to set that up? I've never done it so I want to be sure of how it would be...

HiI'm a bit confused on this priority topic. If I set the spanning-tree priority to "1" on one switch and then "4096" on another, I would assume that the switch with the priority of "4096" would become the root bridge. However some people are telling...

Why use STP if RSTP is so much faster? In what instances would it be a bad idea to use rstp? Anyone?

Hello,We have begun to implement BPDU Guard and UDLD guard in order to prevent layer 2 loops across our network, but have run across an issue with monitoring this solution.I cannot see any command to enable the switches to send an SNMP trap whenever ...

hi, i have a switch 2924-XL and one of its port shows line protocol up but ite LED color is amber stable and the same port is access through a vlan but the connectivity cannot be established whereas if i used 2950 with same senerio it works, is there...