Switching

Hi all, I have just set up a vpn tunnel from site to site, but it does not allow me to ping through it, the error on the logs isAn ICMP session was removed in fast-path when stateful ICMP is enabled using the inspect icmp command.Can anyone helpcheer...

I have a 2900 cisco switch. I have a domain with 4 computers setup, and they are all on vlan 1 the native of course. I am trying to add a 5th but I want it to be on vlan 2. My only route out is my linksys wireless router which then goes out through a...

Per SRNDPer Design guide below, page 44-45 http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/cdccont_0900aecd801a8a2d.pdfand other links http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a00807347ab.shtmlht...

I have a 2 layer architecture so just a bunch of access switches, 2 redundant cores and no distribution switches. All ports are 1GB. I have 2 questions base on what I read on the SRND www.cisco.com/go/srnd1. Is it recommend to use trunk or channel ...

I would like that 3750 switch send me alerts by e-mail when a port state that I choose change.Is it possible?. Thanks.

What's the best way to interpret the show interfaces output, specifically the reliability, txload and rxload statistics. In my situation I'm trying to get an accurate picture of link utilization but I keep getting very disparate results. I've notice...

I have two PIX firewalls 515 and 525 running 6.3. The outside interfaces are connected to the edge router via a DMZ switch. The router and PIX firewalls are running OSPF. Both PIXs are running OSPF on the inside as well, the reason for the two proces...

I inherited a wireless network with multiple wireless AP's connected to two GW's in a mesh configuration. The GW's are wireless AP's as well and are connected to two separate 2950 switches. Each switch is connected to 2621 routers.The AP's hand out...

My router cannot load IOS and it is always loading in bootstrap with the (boot)> symbol. Unfortunately I do not have a backup of the IOS, do you think it has been corrupted? I am pasting some info to help.%SYS-6-BOOT_MESSAGES: Messages above this lin...

HiI am not able to login to 3550 switch.Getting the error insufficient memory to boot the image.Find attached error.

I am not sure why the DRAM prices are so expensive. However, I found this site, http://www.memoryx.net/mem870128d.html , I was wondering if its ok to buy such cheap ram compared to all the other sites. Why is the DRAM so expensive elsewhere?

Hi all , when setting up an asa firewall from scratch, is there a general setup procedure that you should follow ?cheersCarl