Hi, I need to know if two host PCs which are part of the same subnet but are in different VLANs can ping each other if the hosts are connected to two different switches. The switches are also connected by two access ports and those ports are assigned...
Hello FriendsI am looking for a 8 or 12 port cisco switch which could be used to aggergate a couple of 3650 switches. I am looking for a 3650 or 3750 series switch.RegardsKoya
Using the tools available on any cisco router or l3 switch what is the best way to track down someone who has stuck a nice home router on the network and it is handing out those nice 192.168. addresses to everyone on that subnet ? Any good comm...
Hi,I just got a used 3500xl switch at a going out of business sale "as is" and would like to use it in my small office (10 connections). The problem is that I don't know the static IP and the switch appears to be password protected.I have a basic un...
Often see the stat "xyz switch switches 38 mpps". Can we determine the amount of pps a switch is actually pumping through? In my office, where not everyone is Cisco-friendly they often throw up this stat.
Hi all if I have been assigned 5 public ip addresses to my dsl router but want the ethernet interface to be on one of them, would I put the ethernet interface on one of the public ip addresses and then use ip unnumbered for the dialler interface, is ...
We need to take eight ports out of a 3750 switchstack (four ports on two of the members, remaining ports on these members assigned to network devices; three other stack members have ports assigned to servers, printers, desktops, etc) and assign them ...
We have done this on one 6509 and so we have the filesystem on a CF card. This took 2 reboots. 1 to get the image running to extract and "install" and a 2nd time so that the system boots to the extracted filesystem so that it supports patching. Is ...
Hi all, If i was to connect to my isp using a 56k analogue modem, what kind of frames and traffic is it, is it still ip ? I gather they arent ethernet frames ?
I have 4 6509-E switches all the same configuration/hardware/revision/IOS levels. 1 switch fails (all WS-X6748-GE-TX) when "switchport host" command is enters on an interface range. Although a "show run" shows that all interfaces have portfast confi...
I want to give internet access to each one of the 10 VLANs of a building.Can i have a VLAN trunk between the router and the switch, applying a policy map to each vlan (for bandwidth control)?if not, how can this be done?
There is a windows DOS command which measures network response times using TCP traffic. I cannot remember the command. It features in the old CIT CCNP exam. I think it is something like TTCN and has a number variable.Any suggestions please? It is...
Hello all,I got a Switch: 3750-24PS, it is making noise. It sounds like fan issues.captured "show env all" and "show log", no errors found. checked Cisco 3750 data sheet:Cisco Catalyst 3750-24PS: 38-42 dB45dB.Anybody know the acceptable dB range? An...
Hi all,I am trying to find out information on steps to take for upgrading the memory on Cisco 831 routers.I have removed chips from some of my old and broken 831 that I want to use to upgrade the flash memory on my working 831 routers. When I add the...
