Switching

I have a 5505 with SUP3 and 24 10/100 blade , FE-TX blade and gigabit uplink module.The best throughput I get is 45Mbits/s in the same blade. It traffic goes through the uplink module throughput drops to 25Mbits/s. Is it normal? I have two unit and t...

We have a 6509 w/ Sup720 IOS and a WS-X6708-10GE. We notice that we receive large amounts of giants on this interface. Is this normal and should we be concerned, any suggestions? Thx!SW-CA-DC-D2#sh int t1/7TenGigabitEthernet1/7 is up, line protocol i...

Helo,For the sake of me I can't figure this out. I have a NM-ESW 16 port in a 2811 with IOS 12.4(11)XJ4. I need to connect IP phones and PC behind them in the classic access + voice VLAN configuration. What happens, is that as soon the voice vlan is ...

i want to check router serial number how can i check

What would be the reasons for not be able to conntect to the PDM software on a Pix 501? I have a laptop directly plugged into one of the ports and using the following command using IE7 browser:https://10.0.0.1This is the "gateway" address that I rece...

I have attached a pdf file of our current network diagram and a proposed network upgrade layout. We currently have a site with less than 50 workstations, a few servers and networked printers that are all hanging off of 2950T switches and all on the s...

Greetings,OSPF only allows inbound distribute-lists, not outbound. I was wondering if you can apply an access-group outbound to an interface belonging to an OSPF network.

I have a question regarding choice of Layer-3 devices on a mid-size network. This network averages about 1200 client machines and there are 100 servers.Which is a better choice for core and distribution-layer routing? Should I go with four Catalyst...

How do I find the interface index on a 6509? SNMP ineterafce monitoring is not working and they are asking me to verify the index. I know I have seen it before but I can't seem to find it again. Thanks, Dave

Which Supervisor Module would have faster performance on Layer-3 routing? Supervisor-4 on a Catalyst 4506 or a Supervisor-32 PISA on a Catalyst 6506? I would like to know as I am planning an upgrade next year. This is for a medium-sized collapsed ...

IOS Firewall logging mechanism is only displaying firewalling messages even though all logging is enabled. How do you turn on regular IOS router logging, like login, interface up/down?

It's a 6509 with sup720/pfc3b. If I try to create a second monitor session the error returned is "local span limit has been exceeded"I thought the sup720 supported two local span sessions?-----LAB6509#sh monitorSession 1---------Type ...

Hi,Regarding IP-Helper Configuration, when you list IP addresses with the ip-helper address command, does the router forward the broadcast/DHCP/BootP request to the first IP address on the list first or does the router forward the request to all IP a...

I am connecting 3560E switches to a 4507R core switch. Existing fiber connects the IDF locations for the 3560s to the MDF location for the core switch. The multimode fiber plant takes ST connectors. The GBICs - GLC-SX-MM and WS-G5484 - require LC c...