I'm looking to upgrade my 4507R's running IOS version 12.2(20)E) on Sup V's to 12.2.37-SG(ED). I can't find the upgrade instructions can someone point me to them please?Thanks
I'm looking to upgrade my 4507R's running IOS version 12.2(20)E) on Sup V's to 12.2.37-SG(ED). I can't find the upgrade instructions can someone point me to them please?Thanks
Does anyone know anything about Verizon's (or any other carrier's) EPL service? Verizon has a MAN service called TLS (Transparent LAN Switching), which does NOT support QoS/CoS. I guess it has something to do with the manner in which the TLS service ...
Does anyone know anything about Verizon's (or any other carrier's) EPL service? Verizon has a MAN service called TLS (Transparent LAN Switching), which does NOT support QoS/CoS. I guess it has somethign to do with the manner in which the TLS service ...
I have hit a scenario and looking for some techincal help here for any possible work arounds if you have seen similar thing somewhere else. Following is the simplified topology CustomerSwitch1(dot1q)------------(qinq,l2tp)SP-A Switch1(dot1q)--------...
if a server has a default gateway pointing to a firewall and a layer 2 switch is in between the FW and server, can i be able to se the arp entry of server on switch?
Could anyone provide me with a link to some documentation for 10 gigabit blades for a 6500 series switch? I have seen them for fiber but I would like copper blades. Thanks.
Dear All,required urgent help on password recovery for 3560 switch... can somebody guide me please , i searched on cisco site for solutions but nothing worked for me please help
I have a 3750 that is only allowing two ip addresses to pass through a layer 3 port. I need to allow the host to connect to the DHCP server on the other side of the port but have run into problems setting up the access list to allow bootps and bootpc...
hello everybody,Any body can explain about tftp server, like what is it? what is the purpose to use it, where shall we use and how we can utilize it.thanks in advance,naidu.
Have a question about Cisco 3750 Catalysts. If I have stacked switches, say 3 3750's stacked together, what is the maximum throughput from switch to switch I can get. From what I am reading I can get up to 64 Gbps. Is this true because I am also s...
I need ot be educated. Why would someone place a trunk port in a vlan. I always thought of a port as either being one that supports a trunk or one that supports an end-user (access port).Check out this config:interface GigabitEthernet0/48 description...
In my vpn client software, I have the host as x.x.x.x, lets assume that all other configurations are correct, should it connect based on this information? And how about the dns, how would it keep the connection close.ip address outside x.x.x.x 255.25...
This is on a router configured as multicast RP. PIM Sparse mode and MSDP peering are used.When I "sh ip pim rp" on the router, a couple of groups always have "RP-reachable in ..." displayed. Timer just cycles from 00:01:30 to 00:00:00.Group: 224.0.1....
I don't quite understand this concept.i mean i read in a book that if i have some pc's connected to a switch, and i want to connect some ip-phones too - i need native vlan because pc's cannot understand vlan and tagging. that's fine but ISL encapsula...
I configured the Router to a specific DHCP pool . I put also the default gateway, name server etc. After that i configured to exclude some specific range of addresses. But when i write show dhcp ip pool ... i can not see the excluded addresses. How c...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-24-2024 02:27 PM | ||
04-23-2024 02:53 AM | ||
04-19-2024 05:58 AM | ||
04-17-2024 03:50 AM | ||
04-15-2024 06:06 PM |
User | Count |
---|---|
11 | |
11 | |
10 | |
9 | |
6 |