Switching

Hi,We have a devcice with an Ethernet port supposed to be capable of using both 10Mbits/s and 100Mbits/s. Unfortunately the device is unreliable when using 100Mbits/s, so we have to force it to use 10Mbits/s by connecting it to an old 10Mb hub and c...

Hello!Network Design and Config*************************part of the Project Like This:SW1(VLAN100) connected to DS1SwitchB(Vlan200)Connected to DS2;SW1 HAS Stack Link to SW2.DS1 Has L2 Link to DS2i will setup 2 DSs and 20 vlans and Run HSRP Between i...

The overall goal is to have a method of fine granular sniffing (VACL) and transporting the 'sniffed' traffic over an IP network.Equipment I have is a cat3550 running c3550-ipservicesk9-mz.122-25.SEE3. I know ERSPAN exists (6500 w/ sup720) but I want...

I have a customer who is bothered by the boot up message "% ATM1/0 :ILMI disabling will take effect in the next interface restart" that appears on our standby 3845 whenever it is cold booted.I have been unable to explain it to him in terms that will...

Hi,I am planning on deploying URL filtering with the assistance of an Iron Port Sever, however I have not been able to identify the correct way of configuring my 4500 for having all the traffic redirected to the Iron Port Server, I was told that this...

Hello,I have a question regarding the PIX 501 and 506e using PDM. When I first set up the device I am able to connect through PDM using the default settings, however when I change the internal IP interface and configure the laptop I?m using to utiliz...

Hi,Some question from Trunk & EtherChannel1. Can we make a Ethernet ( 10M ) port a trunk ?2. Does it need to be full duplex?3. Can EtherChannel ports be made Trunk ?4. Can we make Ethernet ( 10M ) ports EtherChannel?5. Does it EtherChannle ports nee...

WAN, Routing and Switching: VLAN AND STRIPPING- HELPPosted by: cozyk1515 - Senior Network Admin, PrimeLink - Jun 20, 2007, 8:31am PSTInterface GigabitEthernet1/46- 1/48 are fiber points coming in off my Fiber equipment. INT GIG1/1- 1/4 are going back...

anyone know where I can find a LC to ST fiber patch cable? I need to connect our SFP LC fiber module to our ST fiber patch panel.

Hello,I'm trying to create a trunk across a link that my isp has given to me. I have a 3550 at both ends and I need to move across a couple of vlans.I have tried this config and the trunk comes up, but I cannot transfer any ip information across it....

Hi,I'm trying to implement Netflow on our SUP720 with "time sampled" option with following configuration:ip flow-cache timeout active 1mls flow ip interface-destination-sourcemls nde sender version 5mls sampling time-based 1024sh mls sampling Time-ba...

Just want to know is there any recent threat of "Network worm disabling the Lan environment".If that so pls advice us for disabling that TCP/UDP port

I have a wireless network bridge to wired lan and will need multiple wireless CPE devices off that LAN...I'm curious how to handle multiple 192.168.1.1 subnets throught the rest of the network.....