Switching

Hello,I have a router with syslog enabled. It's not being forwarded to the buffer or a syslog server.I noticed the router has 11XXX messages logged for the console and trap. What is the console/trap logs for? How can I view them?Thanks

Hello all,I need to setup a rule on a router. Any SMTP traffic destined for a certain I.P address must route traffic to a certain address. The Ip Route command can route traffic based on source and destination I.P addressing, but how can I filter t...

I'm looking to create a VLAN on my network that will give users attached to it access only to the Internet and to only 1 IP Printer that is located on my printer VLAN.My internal network is setup in the following manner:10.140.0.0 is carved up into m...

dearI have cisco 50 switches & router.can you suggest any good software for manage switches & router.

We are planning to run DHCP on a router for 5 VLANs with 20 users on each VLAN.Is it a good idea?

Hi all,What is the stacking capabilities in 3750 switches, can anybody explain please.thanks in advance.

Hi,Does anyone knows the pin out assigment for creating a console cable using CAT5 RJ-45. Is it the same as a Crossover?ThanksJorge

Hi All, I have four routers connected to a PC equipped with four serial ports but the HPterminal can only reveal Comm1, which made it impossible to communicate with the remaining routers or even create HPertml for them. How can i locate the rem...

Perhaps someone can help me, as I can't find a clear cut answer anywhere as to how to do, what normally would seem like a simple task.How can I best forward http and https traffic to a host on the LAN side through a Cisco 1720?I'm essentially just lo...

Greetings, I have 3524 and 3548 Catalyst switches. I have performed some trunking on them like I have done many times before however when I perform a "sh vlan br" I notice that ports are not assigned to the vlan 100? is this normal? See config attach...

I am trying to configure an 802.1q tunnel across a 6506 switch with sup720 however when I enable "vlan dot1q tag native" I loose my session and cannot reconnect. What causes this?Please help.

I have a 3600 series router and 3500 series catalyst switch. VLANs were created by assigning subinterfaces in router. Since two days many of my interfaces are showing abnormal input rate which is above the resricted level[restriction made by rate lim...