Switching

In preparation for my CCNA exam I found a test question that is a bit confusing. The config is as follows:Note: the routing protocol is rip(config) int e0(config-if)ip address 192.168.81.33 255.255.255.224config-if)no shutdown(config) int s1config-if...

4503 suddenly rejects telnet sessions.I can console in, but telnet is being rejected by host.No open sessionsHas anyone seen this?

Hi,I have a problem with a CSS configuration. The configuration of the network is as follows. The client request hits the front end VIP of the CSS and is then redirected to the backend server. The requirement is to maintain the connection between ...

Hi folks,I'm trying to find general mtbf data for the PIX-515e & CSS11501 platforms, can anyone help please?Regards,Andy.

Using Catalyst 6504 with MSFC. Host on vlan2 generates multicast. Tunnel source from vlan5 to get around non-multicast elements. Tunnel works - multicast packets are received by listeners on the other end of the tunnel.Within the 6504 MSFC, I want...

I am picking up where a former employee left off. I have Cisco Network Assistant up and running (it's a sweet tool) but I can't access the switch in question. I have downloaded the "How to Access a Cisco Switch when you don't know the password" guide...

We are looking at implementing QOS on our network and are confused on exactly what can be achieved with these switches, our supplier tells us that you can't mark outbound packtes you can only mark inbound packets but reading the 2950 docs it gives th...

Hello AllI have network setup like,CLOUD---CISCO 2621----SWITCH---(LINUX SERVER & CLIENT)I have configured HTTP (Apache) on linux server, its working fine from out side the network. But if suppose i type mydomain.com from internal network than it dos...

Hi,I have WS-6724-SFP cards with and without DCF3B daugther card in the same chassis. How will the fact that some cards have DFC3B and others do not affect the forwarding performance?For exemple, when I have Etherchannels configured that use ports in...

I am currently running Smoothwall and a Cisco 2611 router on my network.On my Smoothwall, ifconfig -a is:eth0 - 192.168.1.1 - greeneth1 - 192.168.5.1 - orangeeth2 - xxx.xx.38.35 - redOn my router, show run is:fa0/0 192.168.1.1fa0/1 192.168.2.1router ...

We just install a NAM-2 on a Cisco 6513, after session into the NAM and configure IP address default gateway, enable HTTP server. NAM can only ping itself, we even can't ping 6513 and gateway. The show IP command shows the right configuration. Accord...

IM RUNNING MY ASA IN TRANSPARENT MODE BETWEEN 2 SWITCHES, CAN ANYONE TELL ME HOW TO ALLOW BPDU'S THROUGH THE FIREWALL ?CHEERSCarl

We have newly bought 7609 and 7613 routers.In these routers we have added a 512MB DDR Ram additionaly and 2x128MB flash memory.I would like to know by which command we can check the additional RAM and Flash memory.

Hi All,I could have sworn I asked this before, but I cannot find in my posts...so I apologize if someone has already answered.I will be putting in a video conferencing solution at my central site in the up coming months. Where I need some direction ...