Switching

Hi AllCan I run CEF with load balancing, also per destination between 2 different Cat 6509 and 2 Different Cat3550 over 2 x 1GB Link?Thanks

Now, I meet some load balance questions in eigrp:1)There are 2 routers from NetA to NetB in Eigrp, and one via Ethernet0 and the other via Serial0.These 2 routers deploy load balance. But now the load balance don't work, even if I change router metri...

Hi, i am on a Vlan10, trying to connect to another Vlan20 through a router, and the switches i used are being connected in a trunk way, i could ping the pcs with the Vlans, but couldnt ping from my Vlan10 to Vlan20

Have a 2950 switch that was configured by another company. Need to change IP address. Tried resetting the switch via documentation but when pressing the mode button switch led's do not blink. Have done this on other 2950 and 2960 switches without a h...

Hello togetherDid someone ever configure a Catalyst 3750 (IP Base Image) with multi VRF and EIGRP Stub? Does this work?Regards Lars

I have not tried that before, but on an interface can we have the primary IP address and the secondary IP address on the same subnet, for exampleinterface fast0/0ip address 10.1.1.1 255.255.255.0ip address 10.1.1.2 255.255.255.0 secWill the router ac...

Hi,I was wondering if anyone had an opinion on the following network design.I am considering using 3750 switches to build server farms. In the first case we will be using 4 48 port 3750's in a stack linked back to a 4507R via SFP GLC-T= ports. The ...

I have an extra Catalyst 3548XL that I want to put into my LAN. The two fiber modules on the unit are 1000base-LX. The rest of my network is 2900 series Catalyst's with 100base fiber links. Is it possible to add this 3548XL into my network and have ...

I have recently enabled QOS on my 6509 (running Hybrid mode).I have noticed that on some of my layer 3 Interface VLANs I am seeing some Input Queue drops and Flushes. Sometimes only Flushes and no drops or Drops and no Flushes and sometimes both. I c...

Hi! Has anynone uses Cisco 831 in their environment? Normally, how does a Cisco 831 routers connect to a main site? Does these Cisco 831 need to be connected through a external Broadband modem and VPN to the main site? or there's any alternative? Wha...

I am quite new to Cisco, I have just taken delivery of a Cisco router I want to use at home unfortunately I don?t have that experience and don?t want to fiddle with the router. I need help urgently to configure it, here is my scenario: I currently h...

Hi dear allI want to limit my cisco switch port into 128K throughput.the policy config on the switch can limit it into 1M but i need 128K or fewer!any solution or suggestion?regards

HI,I am trying to configure VLANs in 2950 switch and connect the trunk ports 16,17 to the router .Now the problem is When I enable any One VLAN interface the other one goes down automatically .for example : #vlan 1#no shutIt automatically gives VLAN ...

Hi all. I have a mysterious case with a NAT pool configured over 2 C2600 (ver 12.2 and ver 12.3) with HSRP. One active, and the other in standby mode.Both routers have 2 nat pools in use. I can see both working with "sh ip nat statistics".The problem...