Hi guys,I would like to seek advice on the concept of specifying a secondary IP address for an interface.I've been reading up at the documentation page but I'm still quite confused.The idea I'm getting is that instead of splitting the network into mu...
I hope I don't get "rapped" in the mouth for this, but I don't quite understand how HSRP works....If I have two 6509's, and I want 6509A to be the primary switch and the second one (6509B) as a "back-up", how would I do this exactly?In other words, I...
Hi All,I am testing a colo router connectivity design as shown in the diagram.Everything is working fine,except the ping between the Gigabit interfaces 1/1.200 on Colo Router1 and Colo Router2.(ie) Pinging between 200.0.0.2 and 200.0.0.3Both the col...
I'm having a bit of mare advertising some routes from one 3750 L3 Switch to another 3750 using OSPF.Both routers below are linked together via 6 foot Cat 6 cable. This interswitch connectivity uses 802.1q trunking. Local routing is fine.Router 1netwo...
Does anyone know what "throttles" mean on 10 interface stats. Is it a issue, whats causing this.Thanks.TenGigabitEthernet1/1 is up, line protocol is up (connected) Hardware is C6k 10000Mb 802.3, address is 0015.c746.4800 (bia 0015.c746.4800) Descr...
Hi,I am trying to locate a matrix which detsils the amount of Ingress policers and egress shapers on all of the catalyst switches. I have a strange feeling that this is not available so in teh absense could someone confirm if teh below is correct.the...
I am currently using a dual core setup with HSRP between two 6509 switches. When Core A goes down everything fails over to Core B quite gracefully. When Core A comes back online my Edge and WAN switch loses all of its EIGRP routes with the Core rou...
Hi all, I have a cisco sb108 dsl router, I copied the config from another router, then I pasted the text file back into the same router, and it will not take the config, It comes up with lots of error detected in ^ markers. Why is this as its the sa...
Home office:3750 switch - 10.0.0.1 / 255.0.0.0default gateway for the 10.0.0.0 network(2) Vlans, 30 for IP phones and 110 for workstations.Pix 515E firewall - 10.0.0.10 / 255.0.0.0Remote office:Pix 506 firewall - 10.20.1.1 / 255.255.255.0There is a v...
I'm having trouble with clients getting the wrong DHCP addresses. It is isolated to one location. The problem is that clients on VLAN 3 are getting addresses for clients on VLAN 1. Now it is not all clients and it is not every time. Sometimes they wi...
I have one problem regarding WS-C6513 switch using CatOS command. I notice that the ports connect from the user to the module ports will keep on shutdown for no reason. The worse part is i have to unshut the port one by one. It really waste a lof of ...
I've managed to get the 2811 router T1 and associated serials up and running and I have the 2960G switch up and running. I connect a PC to the switch port of choice and recieve the proper IP/Subnet Mask/Default Gateway/and all DNS information. Howeve...
I have a network of 4 switches in a ring config, 3 2955 and 1 2950. They have a few different versions of IOS, 12.1(19)EA1c to 12.1(22)EA1. I have RSTP enabled on all switches with default RSTP settings. The backbone ports are set:interface FastEt...
