incorect time on show log

[emmanuel.shoroma]

How can I make the log to show the correct time? I have set the clock on the devices but the sh log still show a wrong time (23w0d). see below

23w0d: %SW_MATM-4-MACFLAP_NOTIF: Host 001c.2303.300d in vlan 10 is flapping betw

een port Gi1/0/41 and port Gi1/0/19

23w0d: %CLEAR-5-COUNTERS: Clear counter on all interfaces by ficadmin on vty1 (1

92.168.24.50)

CENTSWICT02#sh clo

CENTSWICT02#sh clock

.09:30:15.127 SAST Tue Aug 12 2008

[massimiliano.serafino]

Hi,

In global configuration mode you must use:

service timestamps log datetime

I hope this helps.

Best regards.

Massimiliano.

[emmanuel.shoroma]

Thanks.

this was very helpfull. post rated

[massimiliano.serafino]

You're welcome.

Massimiliano.

[mohammedrafiq]

Hi,

I have the same issue on PIX-515, but I cannot use the same command, is any other fix for it?

Regards,

[massimiliano.serafino]

Hi,

You must use the command in global configuration mode:

logging timestamp

I hope this helps.

Best regards.

Massimiliano.

[mohammedrafiq]

but it still giving in wrong format.

111001: Begin configuration: 10.194.1.106 writing to memory

111004: 10.19.1.10 end configuration: OK

111008: User 'enable_15' executed the 'write M' command.

regards,