10-18-2010 07:41 AM - edited 03-06-2019 01:34 PM
I'm trying to implement the following configuration on a Catalyst 4506 running 12.1(20r)EW1.
We have a three MS servers clusterd together. Two of them are on the same 4506.
When I try to enter the static mac address entry I am only allowed to enter one physical port.
switch(config)# mac-address-table static 02bf.0a1b.68fd vlan 20 interface FastEthernet5/8 ?
<cr>
If I try to do two seperate entries the first one is overwritten.
Any suggestions?
Solved! Go to Solution.
10-18-2010 08:01 AM
Hello Tobin,
if you are really running 12.1(20r)EW1 I would suggest an IOS image upgrade as your version is rather old.
This can easily explain why you cannot enter the required command
I have the same problem on a C4500 running 12.2(20)EW
switch(config)#$-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
mac-address-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
^
% Invalid input detected at '^' marker.
Hope to help
Giuseppe
10-18-2010 08:01 AM
Hello Tobin,
if you are really running 12.1(20r)EW1 I would suggest an IOS image upgrade as your version is rather old.
This can easily explain why you cannot enter the required command
I have the same problem on a C4500 running 12.2(20)EW
switch(config)#$-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
mac-address-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
^
% Invalid input detected at '^' marker.
Hope to help
Giuseppe
10-18-2010 08:22 AM
Hi
switch#sh run | i mac.*static
mac address-table static 1111.1111.1111 vlan 10 interface Gi1/2 Gi2/2
On 12.2(53)SG2
HTH
Dan
10-18-2010 08:27 AM
Hello Dan,
thanks this confirms that an IOS upgrade is necessary for the original poster as I have suspected
Hope to help
Giuseppe
10-18-2010 11:24 AM
Thank you both. That explains it. Gives me a good excuse to upgrade the IOS.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide