Our ISP turned up our T1 today. For whatever reason I told them that I would provide the router and configure it myself. Now that I have been staring at this all day I realize I have no clue where to start. Here is what I have: (IPs have been changed for security)
Qwest serial = 10.100.100.57/30
my serial = 10.100.100.58/30
usable IP block: 10.10.10.224/29
eth0: 10.10.10.225
dns = 205.171.3.65
eth 1private lan = 192.168.1.254/24
I configured Serial0 with 10.100.100.58 and setup NAT to my private LAN and that all worked great. But what I am needing to do is place 2 pieces of hardware on the public LAN using the 10.10.10.xxx address assigned to me. I cannot get these machines to do anything on ther Internet. I have bridged the ser0 and eth0, I have tried routing, i have sat and stared. I'm at a loss. Any help will be appreciated.