06-29-2018 08:25 AM - edited 03-08-2019 03:31 PM
Hello Guys,
I am using two 6504E switches and want to configure VSS but i have some confusions. I am following cisco Documentation.
And got stuck on this command.
Step 4 Switch-1(config)# router routing_protocol processID
In my case, right now both switches are configured standalone, connected with each other. Switch one is using the static route towards firewall.
Please advice what to write on this command.
Thanks
Solved! Go to Solution.
06-29-2018 09:08 AM - edited 06-29-2018 09:08 AM
Hi,
Step 4 Switch-1(config)# router routing_protocol processID
This command is used if you are planning to use a routing protocol like OSPF, EIGRP, etc..
Example:
router ospf 10
router eigrp 20
etc..
If you are using static routes, you don't need this command.
HTH
06-29-2018 09:08 AM - edited 06-29-2018 09:08 AM
Hi,
Step 4 Switch-1(config)# router routing_protocol processID
This command is used if you are planning to use a routing protocol like OSPF, EIGRP, etc..
Example:
router ospf 10
router eigrp 20
etc..
If you are using static routes, you don't need this command.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide