restoring 2960c switch to factory defaults without the enable password

[larry.cox]

I have a new 2960c switch that I miss typed the enable secret password in and now would like to return it to the factory defaults to start the conf over again?  Is there any way to do this with out the enable password?

[Ganesh Hariharan]

I have a new 2960c switch that I miss typed the enable secret password in and now would like to return it to the factory defaults to start the conf over again?  Is there any way to do this with out the enable password?

Hello,

Have a look on the below link for step by step procedure for password recovery.

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-2950-series-switches/12040-pswdrec-2900xl.html

Hope it helps..

-GI

Rate if it Helpss