Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Visio Cisco Equipment Shapes out of Proportion and others Missing

Hello Everyone,

Have any of you noticed that the shapes of line cards and port cards are out of proportion with the chassis Visio shape in which you place them.  The ones below leave gaps not representative of the actual physical equipment.  Also, it seems not all the shapes are included with the VSS files.

WS-X45-Sup6-E Supervisor Engine 6-E

WS-X4548-GB-RJ45

WS-X4648-RJ45V+E

WS-X4306-GB

The attached image provides and excellent example of the issue with the current Cisco Visio Shapes.

 

Thanks,

C. Z.

  • Technical Documentation Ideas
1 REPLY
Cisco Employee

Hi CZ,You are correct that

Hi CZ,

You are correct that some of the line cards on that stencil do not fit properly into the chassis.  Those icons/shapes were produced by the previous vendor prior to 2009 when we took this over. The shapes produced by my group do fit correctly, for example the WS-X4748-RJ45-E. The product group did not authorize us to go back to retrofit the older shapes and that's why they do not fit as expected.

Regarding missing shapes, we produce what the product group orders from us but I can often ask them to fund additional shapes when there is a forum request. Please understand that they will not accept requests for end of life products.

Brett Newman
Cisco Visio Development
www.shapesource.com

526
Views
0
Helpful
1
Replies
This widget could not be displayed.