TelePresence and Video Infrastructure

I need to be able to see the status of specific TMS messages coming in to a C40 and C90 codec. Are there any xStatus or xFeedback commands that I can send to get these messages and parse the data in the messages? The codecs are running TC5.1.4 throug...

I am programming a system that needs to automatically wake up on a specific notification from TMS. I could not find anything in the API that will allow me to see an xStatus from TMS. Is there any such command or something I can add to xFeedback to ge...

Hi,I would just like to know wheather calls are possible between two C40 telepresence device without being registered to any of the devices (CUCM, VCS or Webex Telepresence) only on IP address (IP V 4) and H323 protocol within the office network (LAN...

In this enviroment secured communications with the directory server is requried. There is also a load balancer involved when communicating with Active Directory servers so using Kerberos with Active Directory Fails when pointing to AD through the loa...

Hi,This kind a weird question. Is it possible for a video jabber on PC with dual video card to display two different outputs (one output for the farend video and one output for the presentation). Just like on endpoint codecs with dual screen set up. ...

Hello, I am deploying Jabber Movi and would like to preconfigure the application for Windows and Mac with all the basic settings per the admin guide.  I have not/never done Any Windows Installer or Mac preconfiguring.  Is there some step by step guid...

What could be causing TMS to not accurately show the system status of an SX20?  HTTP is enabled on the endpoint and when I force refresh in TMS, it corrects what is displayed.  TMS users are getting concerned when they see a system is not in a call, ...

Hi all,I just try to perform a fresh installation of TMSPE.When i arrive at SQL step, i could not pass it.I faced with this page but i dont have any idea what to do, what is username/password exc.Is there somebody who has any idea about this?Regards,...

I have a new EX60 running TC6.2 and my computer connected to the EX60 was not able to get an IP from the DHCP pool.  Setting in the network portion of the EX60 were Auto and 1 for VLAN, same as my other EX60s, but I could only get my PC to work when ...

Hello,We have a customer that requires a VTC bridge. Currently, they have 1 C40 located at the headquarters and 5 MXPs located at different locations. All of these end points are using ISDN and can make unclass and classified connections (secure) usi...

                   I have a MXP 95 in a far location that has registed to the VCS but is saying registration failed on the endpoint. I can ping all round the network fine and make a direct call from a endpoint in my office to the far end endpoint wit...

Thanks ahead of time for any help on this.I was doing a wireshark capture of both the free version of Jabber and the Enterprise version and came across a media routing issue that's rather perplexing.The client (Movi/Jabber) was on a NAT'd guest netwo...

HiI'v got 4 sites - cisco sx20 and EX90.When i call all the sites i can coonect.. but when they try to connect me - we can't connect.The problem is only with H323 because with SIP it's working OK and we can't connect in both sides.The problem it's in...