Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6000MXP Endpoint software upgrade

Hi,

We currently have a 6000MXP codec running F3.2 software.  Is there a specific upgrade path that I must follow to upgrade to F3.9?

Are there any licensing considerations?

Many thanks

Oliver

1 REPLY
Cisco Employee

6000MXP Endpoint software upgrade

You can always upgrade to a minor version without a key (e.g. F3.0 to F3.5) but if you jump from F3.x to F4.x (or higher) you would need a key for the version you are upgrading to.

As far as I can see there is no F3.9?

I beleive there was a change in the software around F4 so that if you wanted to upgrade from F3.5 to F9.1 you would have to go via F4.x otherwise the upgrade would fail.

You can always check the release notes here ....

336
Views
0
Helpful
1
Replies
CreatePlease login to create content