Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ad-Hoc conference with Conductor and CUCM shows on hold

I have a MRGL setup that has conductor in in (CUCM 10.5).  I place a call between an SX80 and an MX300.  From either endpoint, if I add in a third party from either endpoint, an ad-hoc conference does get created and all parties are successfully conferenced together, but for some reason both the SX80 and MX300 have message on the display that they have a call on hold.  Is that by design?  Is there a way to disable that notification?

Thanks,  Mike

8 REPLIES
New Member

Funny enough, once in the ad

Funny enough, once in the ad-hoc conference, if I press hold on the SX or MX, then un-hold and rejoin the conference, the on hold message goes away.  Seems like a bug to me.  Just not sure with who...

Cisco Employee

Hi Mike,Could you advise the

Hi Mike,

Could you advise the version and type of bridge being used and if it is behind a conductor, and the version of TC code on the endpoints?  I haven't seen this behavior but I'd like to test it if possible.

-Jonathan

New Member

Conductor XC2.3TP Server 4.0

Conductor XC2.3
TP Server 4.0(1.57)
TC7.2.0.aea6651 for both SX and MX.

Thanks,  Mike

New Member

Hi Mike,I don't know if your

Hi Mike,

I don't know if your problem was ever resolved but I have the same issue with CUCM 10.5, latest version of Conductor, TP server and MX300 G2 endpoints.

Cisco has confirmed that this is a bug and will release a TC7.3 version to the endpoints before the end of november 2014.

Thanks.
Carsten

New Member

No, never heard back from

No, never heard back from anyone.  Thanks for the heads up.

Hi,kindly check the below

Hi,

kindly check the below things:

-TP conductor registration in CUCM

-TP conductor assigned to MRG,MRGL and assigned to device pool.

-In the endpoint settings make sure you use the MRGL for video conference not the multisite. you can find it under the endpoint config in the call manager.

-In the web page for the endpoints, under the provisioning. make sure the multiway is set to auto.

HTH

Anas

don't forget to rate the helpful posts

New Member

Hi Jonathan.  Were you able

Hi Jonathan.  Were you able to find anything on this?  Thanks,  Mike

New Member

Re: Ad-Hoc conference with Conductor and CUCM shows on hold

Hello MIKE,

Could you please provide me with  the conference alias for your adhoc conference? I don't know why the adhoc conference cannot be created. The Rendezvous conference is working

Thanks in anticipation

 

Collins

 

694
Views
5
Helpful
8
Replies
CreatePlease to create content