Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Adding a Second MCU

I'm in the process of adding in a second MCU into my environment.

 

In my original bridge, I have conference factory for ad-hoc calling and use it with TMS for scheduling meetings using a 4501.

I now have a 5310 which I want to integrate.

I can't cascade them.

Is there a way to have them aware of conferences on each unit for failover?

Is it easier to setup one for conferencing calling and the other for reserved calling?

How does conference factory behave with two available bridges.  Will it every route a request to another bridge based off port resources?

Should I just make one for conference factor and put the other in port reservation mode (scheduled meetings)?

 

 

 

 

52
Views
0
Helpful
0
Replies
CreatePlease login to create content