Back-light issue with the Cisco TelePresence SpeakerTrack 60
My client is having an issue with the back-light setting on the new Cisco TelePresence SpeakerTrack 60.
Their codec is a c40 on firmware version 7.1.4
They have just installed the SpeakerTrack 60 in place of a single camera. When the client connects a call the image is very dull. If the client turns the camera back-light off on the codec, and then back on again during the call the image brightens again.
When it was a single camera system the back-light worked perfectly fine.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.