Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

block incoming and outgoing calls for some phones

 

 

Dear All

 

I have some phones like kitchen , i want to block incoming and outgoing calls for these kitchen's phones and i want these phones to call only internally . i have E1 with H323 gateway . how the configuration it will be in CSS and Partition ?

 

 

thanks and regards

 

 

 

1 ACCEPTED SOLUTION

Accepted Solutions

Ideally, you need two CSSs

Ideally, you need two CSSs for this -  a gateway CSS and a device CSS. Assign the kitchen extension a new partition. Add this new partition to the device CSS but not to the gateway CSS. This way incoming calls are blocked.

For outbound calls, you will need another partition and CSS. The partition should contain the pattern 9.! (or whatever your outside access code is) and should block it. It can be translation or route pattern depending on your CUCM's dial plan design. This pattern will be assigned to a new CSS called Block_All (or something) and this should be assigned on the line level.

Please rate useful posts.
1 REPLY

Ideally, you need two CSSs

Ideally, you need two CSSs for this -  a gateway CSS and a device CSS. Assign the kitchen extension a new partition. Add this new partition to the device CSS but not to the gateway CSS. This way incoming calls are blocked.

For outbound calls, you will need another partition and CSS. The partition should contain the pattern 9.! (or whatever your outside access code is) and should block it. It can be translation or route pattern depending on your CUCM's dial plan design. This pattern will be assigned to a new CSS called Block_All (or something) and this should be assigned on the line level.

Please rate useful posts.
60
Views
0
Helpful
1
Replies
CreatePlease login to create content