Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

C 90

i have C 90 . i plug  ON the but system not show the MENU and  Camera Show self view when i move the Camera .

Yasir Vistro        

Yasir Vistro
1 REPLY
Cisco Employee

Re: C 90

Hi,

Are you using the default cable setup?

You probably need to change the screen output for the OSD-menu. This is documented in the C90 Administrator Guide

An outline for you:

Moving the OSD using the remote control

If the main monitor is connected to DVI-I 2 video output you

must run the following shortcut or key sequence on the remote

control.

• Disconnect * # * # 0 X #

X=1 (HDMI 1) X=2 (DVI–I 2)

X=3 (HDMI 3) X=4 (DVI–I 4)

You can also move the OSD in the CLI and by logging on to the codec through HTTP

/Marius

156
Views
0
Helpful
1
Replies