So far have you done any project with C-series codec with Barco XDS control module? I have experience where the Barco XDS module is working fine with TC ver2.0 but not latest TC ver 6.12 ( in both case are using different C60 codec). I was told from barco side the service require to enable only http and telnet at codec side.
Any idea on this or similar scenerio using third party control interface?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.