I have just set up a C20 VTC in our conference room. This equipment was purchased before I got to here and after setting it up I have found out that our company only has ISDN VTC. So I need to get a converter from IP to ISDN. From searching online and forums posts it sounds like I could use the Cisco TelePresence ISDN Link. Is this correct? I want to get verification that this would work before presenting it up and putting in a purchase request.
As Martin has mentioned, the Cisco TelePresence ISDN Link will be a good solution for a single device. But if you have multiple devices on site that require ISDN, you may want to look in to one of the larger ISDN Gateway products (ie a Cisco TelePresence ISDN GW 3241) adn converting all your intra site traffic to IP.
Please remember to rate responses and to mark your question as answered if appropriate.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.