I have a c40 and one 12x and one 4x camera. The First camera comes back in the xstatus as true. Camera 2 comes back as flase. I have tried various cable pinouts and have been unccessful in geting the control to work on the second camera.
I have swapped the camera positions as well to make sure they are both working, and they both work via the remote. Any thoughts?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.