Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

C40 how to disable the local camera content being the default display on the Presentation screen when there is no Presentation

We have a Lecture room setup with a C40.

We have several projectors that we can control which content from the codec is displayed on which projector.

When this room is in a live VC call and the far end is talking/active with Presentation - all is well main projector has Live, other 2 Projectors have Presentation stream. Issue is when the Presentation content stops from the Far End, & the person is still actively talking - the local 2 Projectors which did have the Presentation now show the local Codec Camera on the screens. Would prefer they just go black. As the local Camera may or may not have anyone in it.

Any ideas would be appreciated.

Thank you

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Do you care about selfview on

Do you care about selfview on the second display output going to your presentation projectors?  Try changing the 2nd display output mode to presentaiton only.  I assume it's set to dual right now?

5 REPLIES
Cisco Employee

Hi, This community is

Hi,

 

This community is observed by Cisco Unified MeetingPlace and Cisco WebEx Meetings Server experts. Since you need help with Telepresence, in order to get attention of TP experts, I would advise you to move this post to Telepresence community.

I hope this helps.

-Dejan

VIP Purple

Do you care about selfview on

Do you care about selfview on the second display output going to your presentation projectors?  Try changing the 2nd display output mode to presentaiton only.  I assume it's set to dual right now?

In addition to what has been

In addition to what has been written above, if you wanted the maintain the selfview, you could display it as a PiP on the main screen. Presentation is set to the secondary output, and selfview fullscreen mode set to 'off' and the monitor role set to primary.

Cheers

Chris

Try loging into the unit via

Try loging into the unit via SSH and typing:

xConfiguration Video SelviewDefault Mode: Off

New Member

Thanks all for the replies &

Thanks all for the replies & ideas.

Yes dual displays.

Went for the easy option to change 2nd display output mode to presentation only.

Self view isn’t important at the moment.

Thanks again!

146
Views
0
Helpful
5
Replies