Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

C40 talking to C20's

Guys,

I have a C40 and 2 C20's which I want to only allow them to talk to each other.  I also purchase the Multisite license. Devices located at 3 different sites over our MPLS network. 

Does anyone have a sample configuration or drawning I can used as a templete to set this up?  Is there any thing special I need to do? 

Is there a step by step document out there?

thanks

1 REPLY
VIP Green

C40 talking to C20's

If you only have the three codecs and no other devices, by default, you should be able to dial from one of the endpoints to another by dialling the remote device's IP address.

That'd be the quickest and easiest option for you - add each of the other devices in to the phonebooks on each device so you can find/dial them easily.

Wayne

--

Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
188
Views
0
Helpful
1
Replies