Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Call between TP 3200 and TP 1300-65 question

Hi,

question pls, an active call between TP 3200 and TP 1300-65, what is the normal behavior display output to TP3200 perpective or 3 screens? (showing the TP 1300-65 room) Should it only have the middle screen active and the left and right are idle black?

 

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Not having access to one, I'm

Not having access to one, I'm unable to test, but yes, I'd say that the TX-1300 (being only a single screen system) would only show up on the single (centre) screen of the CTS-3200 and the other two would remain blank (or show other parties if connected).

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
1 REPLY
VIP Purple

Not having access to one, I'm

Not having access to one, I'm unable to test, but yes, I'd say that the TX-1300 (being only a single screen system) would only show up on the single (centre) screen of the CTS-3200 and the other two would remain blank (or show other parties if connected).

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
37
Views
0
Helpful
1
Replies
CreatePlease to create content