Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call does not work between two SX80

 

Hello,

    I have two SX80 TelePresence Devices installed on same Network. I want to make call ( IP to IP ) between two Sx80 and the Result was no call Establish between them.

Are there any configuration required to do it from my side to add to the SX80?

Note: this two SX80 WORKING stand alone ( No CUCM or MCU).

 

Warm Regard,

Idris

3 REPLIES

Log in to both using SSH and

Log in using SSH and ping one from the other to see if they can see each other, also ensure CallSetUp Mode is set to "Direct" and set default call protocol to H.323.

/jens

Please rate replies and mark question(s) as "answered" if applicable.

 

Please rate replies and mark question(s) as "answered" if applicable.
New Member

  thanks Jens Didriksen How

 

 

thanks Jens Didriksen

 How can make the H323 THE default call protocol ?

New Member

Thanks a lot. Jens Didriksen.

248
Views
1
Helpful
3
Replies