Currently when you dial a SIP endpoint from an H323 endpoint, the MXP displays the caller as H323@192.168.1.100, that IP being the IP of the VCS. I was wondering if anyone had a working example of a CPL file which would replace the IP address with a domain name.
Additionally, we are having issues with the caller ID on our CUCM registered phones displaying the correct information for VCS registered endpoints. In most cases, no mater the type of endpoint, software version, or call protocol, the name is displayed as "Unknown". Any assistance would be appreciated.
Starting with CUCM 8.6 the display Name could be display correctly on the phones. The call back URI is often displayed wrong, depnding on the firmware and phine model. If you integrate with CUCM I would recomend to also use SIP as primary call protocol.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...