I give a mxp 95 at a far location over a satellite link at 512 k. When I try to establish a call to it from the mcu the max rate the call will establish at is 192k. There is no max bandwidth set on the codec or mcu. Any ideas
Hard to tell. You can run xcon and xstat to see the config and status of the system. Then run: syslog on, place the call so we can see whats be requested in both directions for BW etc. Should to see. 192 for video? What audio codec is in use?
Does the call estabish at a different rate if your dial it in the opposite direction (endpoint to MCU)? Could help to pinpoint where the cause of the issue is, on the endpoint, or on the MCU, or something else?
Please remember to rate responses and to mark your question as answered if appropriate.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4