Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can the E20 TE4.1 use conf feature?

Can an E20 running TE4.1 make 3-way conference when registered in a SIP PBX (ex: Asterisk)?

I tried transfer and hold, but i´m not sure if conf feature can be done...

Thanks

6 REPLIES
New Member

Can the E20 TE4.1 use conf feature?

Any tips on tips on this?

Thanks

Bronze

Can the E20 TE4.1 use conf feature?

Hi Elter,

Please have a look to administrator guide, it specify that we need to use multiway configuration to make conference call.

Here is the link for admin guide:

www.cisco.com/en/US/docs/telepresence/endpoint/ip-video-phone-e20/te4/administration_guide/cisc

o_ip_video_phone_e20_administrator_guide_te41.pdf

On page 15, you will find complete detail about conference call.

You can use GUI or following command to configure multiway address:

xConfiguration SIP Profile 3 MultiWayConference : IP address of Multiway server

Thanks,

Vivek

New Member

Can the E20 TE4.1 use conf feature?

Hi Vivek. Thanks.

I´m aware of Multiway, but what we need is to register the E20 only/directly to a SIP server (other than VCS o CUCM) like Asterisk and try to make a conf call, like any regular SIP phone or softphone.

regards

Bronze

Can the E20 TE4.1 use conf feature?

Elter,

I am not sure, whether it's going to work, i have to check.

Regards,

Vivek

Can the E20 TE4.1 use conf feature?

Hi Elter

E20 dont have embedded multisite fot initiate 3-way conference.

For use multiway function you must have Cisco MCU and VCS.

Br. Oleksandr

br Oleksandr

Can the E20 TE4.1 use conf feature?

Like Oleksandr already wrote, some endpoints do not offer multisite, like E20, C20, EX60, ...

But you still have the option to buy a MCU and also register asterisk to it or if this is

to costly get at least one endpoint which supports multisite (Edge, C40, EX90,...)

to run multiparty calls.

If you google a bit you will also find some basic capability of doing a switching multiparty

calls with asterisk, but this might require some work and an asterisk forum / mailinglist

would be a better place to address it.

Please remember to rate helpful responses and identify

864
Views
0
Helpful
6
Replies
CreatePlease login to create content