Cannot create new Tandberg Movi users after administrator left...
We are running a little older version of the Tandberg TMS (12.6). It uses OpenDS. Problem is that the person that installed it, and configured it, and administered it, has left the company. If we disable his AD account, and try to add new users to a security group and then try to sync that group in provisioning in TMS, it will not get the new users. If we re-enable his account, then try to sync again, it imports the users accounts in and they can use movi/jabber. Trying to figure out where he username could be set. I checked in the Active Directory section in Network settings, and it has our service account. Any idea where his account could be where it is keying off it to import new users successfully?
Re: Cannot create new Tandberg Movi users after administrator le
When importing users from AD for Jabber accounts, you use a different page, you should check the provisioning directory page. In TMS 12.6, I guess this page is located in System >> Provisioning >> Directory. Take a look at the session External Source Configuration, you will find the credentials used to import users from AD.
I hope this help.
Please rate replies and mark question as "answered" if applicable.
Was my response helpful? Please rate useful replies and remember to mark any solved questions as "answered".
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...