03-28-2014 12:15 PM - edited 03-18-2019 02:48 AM
Hello,
I have CUCM 9.1 clusted with a SIP trunk to a VCS-C. When making calls, the calls show a caller-id of extenstion@ip address, for exampe 2500@172.16.1.5. I have a directory URI setup on the phone that is generating the call, but it's now showing the URI. Inbound SIP URI calls are working fine.
Thanks
Solved! Go to Solution.
03-28-2014 01:11 PM
Hello,
On the SIP trunk to VCS, under outbound calls, there should be a setting: Calling and Connected Party format, change it to Deliver URI only in connected party. Also, under the SIP profile assigned to the SIP trunk to VCS, there should be a setting Use Fully qualified domain in requests, check this checkbox. The SIP profile should also be assigned to the SIP device making calls.
HTH, if so please rate.
03-28-2014 01:11 PM
Hello,
On the SIP trunk to VCS, under outbound calls, there should be a setting: Calling and Connected Party format, change it to Deliver URI only in connected party. Also, under the SIP profile assigned to the SIP trunk to VCS, there should be a setting Use Fully qualified domain in requests, check this checkbox. The SIP profile should also be assigned to the SIP device making calls.
HTH, if so please rate.
03-04-2015 05:00 AM
03-04-2015 08:20 AM
Did you create a directory URI under the extension?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: