Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing calling id / name for SIP URI calls to VCS

Hello,

I have CUCM 9.1 clusted with a SIP trunk to a VCS-C.  When making calls, the calls show a caller-id of extenstion@ip address, for exampe 2500@172.16.1.5.  I have a directory URI setup on the phone that is generating the call, but it's now showing the URI.  Inbound SIP URI calls are working fine.

 

Thanks

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

Hello,On the SIP trunk to VCS

Hello,

On the SIP trunk to VCS, under outbound calls, there should be a setting: Calling and Connected Party format, change it to Deliver URI only in connected party. Also, under the SIP profile assigned to the SIP trunk to VCS, there should be a setting Use Fully qualified domain in requests, check this checkbox. The SIP profile should also be assigned to the SIP device making calls.

HTH, if so please rate.

Please rate useful posts.
3 REPLIES

Hello,On the SIP trunk to VCS

Hello,

On the SIP trunk to VCS, under outbound calls, there should be a setting: Calling and Connected Party format, change it to Deliver URI only in connected party. Also, under the SIP profile assigned to the SIP trunk to VCS, there should be a setting Use Fully qualified domain in requests, check this checkbox. The SIP profile should also be assigned to the SIP device making calls.

HTH, if so please rate.

Please rate useful posts.
New Member

Hello, I've made above

Hello,

 

I've made above changes but I still see the IP address of the cucm instead of the domain in the URI...

See attached screenshots.

rgds, Geert.

Did you create a directory

Did you create a directory URI under the extension?

Please rate useful posts.
808
Views
0
Helpful
3
Replies