I have talked with Vaddio about the possibility of Cisco sending a code to the Vaddio Camera to frost the glass when it goes to "privacy" mode. They say the only way to do that is send the Power off command.Is there a way Cisco can be made to send "Power Off" to the camera for privacy and send " Power On" when it wakes up? The camera codes are CAM Power ON 8x 01 04 00 02 FF, OFF 8x 01 04 00 03 FF
The C-Series has the standby option available but does not turn off the camera. Could it? I would recommend contacting your Cisco account team to submit this feature request to see if it is possible to make that an option. In the meantime, it should be possible for the camera to be controlled by a 3rd party controller that would send the "power off" visca command.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...