I don't have an Edge codec, however basing that it's an MXP codec, and looking at a 3000 MXP. When you access the codec through SSH, and type ? (question mark), do you see the following command: xHistory? If so, that will give you all the call history that codec currently has stored.
You are absolutely right Wayne Sir, because same here I m getting call history 20 record by xhistory command but when i have done reboot the system then call record has been removed so i want to just confirm from you that call history has been removed or not after restart the system.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...