Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco EX90 going to the maintenance mode.

Had configured a cisco EX90 with a static ip address of 172.19.100.40 and after a few days, when trying to connect the EX90 to the network, it was going to the maintenance mode and was giving an error like " The system has encountered with a problem and contact with the system admin." Tried the Factory reset also, but it was giving the same error. 

What could be the possible reason for this..??

 

Regards,
Nithin.

 

 

 

2 REPLIES
VIP Green

It is possible the software

It is possible the software of configuration has been corrupted somehow.

Usually re-installing or upgrading the software on the codec fixes the issue.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
New Member

Hi Nithin, Can you please

Hi Nithin,

 

Can you please tell e the software version and and if you have recently upgraded or downgraded the software?

Deepaksi Multimedia Specilist CCNA+CCNA(Voice)+CCNA(Video)
113
Views
0
Helpful
2
Replies