06-20-2017 07:50 AM - edited 03-18-2019 01:14 PM
Hi
i have a cisco sx80 and isdn link with pairing enabled
after making a factory reset of sx80 and restoring the old configuration and when i try to add the isdn lik aging for pairing i don't found it
what should i do pair the isdn link again
regards
08-28-2017 05:10 PM
The ISDNLink and the codec must both have IPv6 enabled for them to pair correctly. Your screenshot shows that there is no IPv6 on your device.
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Please remember to mark helpful responses and to set your question as answered if appropriate.
06-21-2018 11:46 AM
You need to use SSH to unpair the ISDN Link manually.
use the command below:
xcommand PairRestart Confirm: Yes
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide