Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Cisco MCU MSE 8510 - guest PIN doesn't work

Hi,

We have few conferences setup on the 8510 blade. Each conference has the main PIN and the Guest PIN configured. When I dial into the conference, main PIN works fine but the guest PIN doesn't work.

I tried dialing in with the PIN from one endpoint, and then with the guest PIN from the other endpoint but the conference doesn't accept guest PIN. I can use the main PIN on both endpoints though.

Does anyone know what the issue may be?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

I just tested this without

I just tested this without 8510, no issues at all.

Can you give us a screenshot of how your conference is configured?

I had used the same Numeric ID for both chair and guest, with a different PIN for each.  When I connected as chair, I went straight in.  When I connected as guest, I went straight in, however I got a prompt saying saying on chairman to arrive or connect.

2 REPLIES
VIP Purple

I just tested this without

I just tested this without 8510, no issues at all.

Can you give us a screenshot of how your conference is configured?

I had used the same Numeric ID for both chair and guest, with a different PIN for each.  When I connected as chair, I went straight in.  When I connected as guest, I went straight in, however I got a prompt saying saying on chairman to arrive or connect.

The issue is now resolved:

The issue is now resolved: Guest Numeric ID field was empty. Thanks for the advice!

90
Views
0
Helpful
2
Replies
CreatePlease to create content