Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco SX80 Intial Config

Is there a way to initially sign into the SX80 without having a DHCP port?  I need to start the setup but as of right now the place that I'm working in does not have any active ports to plug into to.

3 REPLIES
Cisco Employee

You can give it a static IP

You can give it a static IP address via the touch panel and direct connect a PC to it (give the PC a static IP on the same subnet) and once you do that you should be able to get to the web GUI and do everything else from there

New Member

I mean before I can even get

I mean before I can even get to the splash screen on the TP you have the welcome screen that requires a DHCP port to read before you can even do anything.  Cisco firmware tc 8

You can plug your laptop into

You can plug your laptop into Ethernet port 2 or 3 on the SX80, set your laptop to DHCP; then open a web browser and navigate to 169.254.1.1 to access the codec.

Justin

Thank you,
Justin Ferello
Technical Support Specialist, ScanSource KBZ
40
Views
0
Helpful
3
Replies
CreatePlease login to create content